Sikafloor Multidur EB-20

Grip that still works with grease on the floor

Sikafloor Multidur EB-20 is fully broadcast, which gives a pronounced anti-slip texture: class R12 with displacement space V6 according to DIN 51130. The V6 is the figure that counts where grease, oil or water reaches the floor: how much liquid can escape beneath the shoe before the surface becomes slippery.

The figures

• Nominal thickness 2 to 4 mm, based on solvent-free epoxy resin
• Compressive strength of the topcoat 140 N/mm2 according to EN ISO 604
• Flexural strength of the topcoat 45 N/mm2 according to ISO 178
• Tensile adhesion strength at least 1.5 N/mm2 with concrete failure according to EN 1542
• Slip resistance class R12 with displacement space V6 according to DIN 51130
• Reaction to fire tested according to EN 13501-1

Where we apply this

• Food industry and production areas with wet or greasy conditions
• Workshops with oil and coolant
• Logistics areas and loading bays
• Indoor parking decks

Installation and maintenance

The system is low-odour during application and low in emissions; the topcoat meets the AgBB emission requirements and has French emission class A plus. The floor takes foot traffic after approx. 24 hours and light loads after approx. 4 days. A coarse profile is cleaned with a brush or scrubber-drier so that dirt is lifted out of the texture; mopping alone is not enough.

When EB-10 is sufficient

If the space is mainly dry and wear resistance under vehicle traffic is the main concern, Sikafloor Multidur EB-10 is sufficient: less coarse and easier to keep clean.